|
TrakRack |
Big Box Retail |
|
 |
 |
11 gauge horizontal rail
3.05 mm metal
61% thicker |
14 gauge horizontal rail
1.897 mm metal |
| Mounts at the ceiling header. No need for a level or studfinder. |
Need to find studs and you must use a level. |
| Mounts with lag bolts on the horizontal rail. |
Mounts with screws on both the horizontal and vertical rails. |
| There are no holes down the walls. |
There are holes down the walls where the vertical rails mount. |
| Attach the vertical rails ANYWHERE on the horizontal rail. |
Must attach the vertical rails at a specific location on the
horizontal rail. |
| Brackets to easily hang cabinets and pegboard. |
Cabinet brackets are not available. |
| Ours are strong enough for commercial / industrial uses. |
Theirs are intended for light-duty residential use only. |
Verticals,
1.25" X 1.25"
25% thicker |
Verticals,
1" X 1" |
Vertical rails use 12 gauge metal
2.656 mm
40% thicker |
Vertical rails use 14 gauge metal
1.897 mm |
| We use a strong "T" design for more metal holding the brackets.
The "T" also allows us to be a universal mount for various other
products that would otherwise require putting holes in your wall. |
They use a double slot design. Less metal holding the brackets. More
difficult to install if brackets get bent. One use only |
| Our shelving can be continuous without any unstable overhang. |
Can install only one section at a time with bracket overhang. |
| Our wire shelf has 4mm
deck rods spaced 1 inch on center & welded at every intersection & oversized
6mm lateral wire spaced every 4 inches. |
Their wire shelves have smaller
deck rods & slave wire spacing at the most every 6 inches. |
Brackets are 11 gauge
3.05 mm metal
61% thicker |
Brackets are 14 gauge
1.897 mm metal |
TrakRackCommercial.com
TrakRack
Corporate Commercial Homepage
TrakRack Commercial Division Contact information:
Bruce Cloud,
Jr.,
Commercial, General Manager
bcloud@trakrack.com
Fax: 512-858-7598
Direct #: 512-422-2912
USA: 800-689-9055
P.O. Box 1225,
Dripping Springs, TX
78620-1225
